Diagnostic Procedure
- If using CONSULT-II, go to next step. If using generic scan tool, go to step 3.
- Turn ignition on. Select SELF-DIAG RESULTS mode with CONSULT-II. Press ERASE. Repeat DTC CONFIRMATION TEST . If 1st trip DTC is detected, replace ECM. See ENGINE CONTROL MODULE REPLACEMENT under ENGINE CONTROL MODULE. If 1st trip DTC is not detected, test is complete.
- Turn ignition on. Select MODE 4 with scan tool. Press ERASE. Repeat DTC CONFIRMATION TEST . If 1st trip DTC is detected, replace ECM. See ENGINE CONTROL MODULE REPLACEMENT under ENGINE CONTROL MODULE. If 1st trip DTC is not detected, test is complete.