ECM Relay

NOTE: ECM relay testing information for FX35, FX45 and G35 is not available from the manufacturer.

For relay location, see Fig 1 - Fig 4 . Remove ECM relay. Using jumper wires, apply battery to terminals No. 1 and 2. See Fig 5.
Continuity should exist between terminals No. 3 and 5, and between terminals No. 6 and 7. Remove jumper wires. Continuity should not exist. If continuity is not as specified, replace relay.

Fig 1: Locating ECM Relay (FX35 & FX45)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Locating ECM Relay (G35)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Locating ECM Relay (I35)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: Locating ECM Relay (M45 Shown; Q45 Is Similar)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 5: Testing ECM Relay (I35, M45, QX4 & Q45)

Courtesy of NISSAN MOTOR CO., U.S.A.