DTC Confirmation Procedure

WARNING: This page is about a different car, the 2004 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If DTC confirmation procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

Testing condition

Before performing the following procedure, confirm that battery voltage is more than 11V when engine is running .

With CONSULT-II

Turn ignition switch ON and wait at least 2 seconds.
Select DATA MONITOR mode with CONSULT-II. See Figure .
Start engine and let it idle for 5 seconds.
If DTC is detected, go to DIAGNOSTIC PROCEDURE .

With GST

Follow the procedure With CONSULT-II above.