DTC confirmation procedure

WARNING: This page is about a different car, the 2004 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If DTC confirmation procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

With CONSULT-II

Turn ignition switch OFF and wait at least 10 seconds.

NOTE: Do not depress accelerator pedal even slightly.

Fig 1: Selecting Data Monitor Mode (CONSULT-II)

Courtesy of NISSAN MOTOR CO., U.S.A.

Turn ignition switch ON and select DATA MONITOR mode with CONSULT-II.
Start engine and wait at least 40 seconds.

If 1st trip DTC is detected, Go to DIAGNOSTIC PROCEDURE .

With GST

Follow the procedure with CONSULT-II above.