Diagnostic Trouble Code (DTC) Confirmation Procedure: Notes
NOTE:
- If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- If the target idle speed is out of the specified value, perform "Idle Air Volume Learning " before conducting DTC Confirmation Procedure. For the target idle speed, refer to theSERVICE DATA AND SPECIFICATIONS (SDS) .
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is more than 11V at idle.
- Always perform the test at a temperature above -10°C (14°F).