Accelerator Pedal Position Sensor

Reconnect all harness connectors disconnected.
Turn ignition switch ON.
Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.

Fig 1: Accelerator Pedal Position Sensor Component Inspection
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Accelerator Pedal Position Sensor Test Conditions
Courtesy of NISSAN MOTOR CO., U.S.A.
If NG, replace accelerator pedal assembly and go to next step.
Perform "Accelerator Pedal Released Position Learning ".
Perform "Throttle Valve Closed Position Learning ".
"Idle Air Volume Learning ".