Operation Procedure
- Perform CONSULT-II SETTING PROCEDURE. Refer to CONSULT-II SETTING PROCEDURE
- Touch "DATA MONITOR".
- Select from "SELECT MONITOR ITEM", screen of data monitor mode is displayed.NOTE: When malfunction is detected, CONSULT-II performs REAL-TIME DIAGNOSIS.
Also, any malfunction detected while in this mode will be displayed at real time.
DISPLAY ITEM LIST
| x: Standard -: Not applicable | ||||
|---|---|---|---|---|
| Monitored item (Unit) | Monitor item selection | Remarks | ||
| ECU INPUT SIGNALS | MAIN SIGNALS | SELECTION FROM MENU | ||
| FR RH SENSOR [km/h] or [mph] | x | x | x | Wheel speed calculated by front wheel sensor RH signal is displayed. |
| FR LH SENSOR [km/h] or [mph] | x | x | x | Wheel speed calculated by front wheel sensor LH signal is displayed. |
| RR RH SENSOR [km/h] or [mph] | x | x | x | Wheel speed calculated by rear wheel sensor RH signal is displayed. |
| RR LH SENSOR [km/h] or [mph] | x | x | x | Wheel speed calculated by rear wheel sensor LH signal is displayed. |
| BATTERY VOLT [V] | - | - | x | Power supply voltage for AWD control unit |
| THRTL POS SEN [%] | - | - | x | Throttle opening status is displayed. |
| ETS SOLENOID [A] | - | - | x | Monitored value of current at AWD solenoid |
| STOP LAMP SW [ON/OFF] | - | - | x | Stop lamp switch signal status via CAN communication line is displayed. |
| ENG SPEED SIG [RUN/STOP] | - | - | x | Engine status is displayed. |
| ETS ACTUATOR [ON/OFF] | - | - | x | Operating condition of AWD actuator relay (integrated in AWD control unit) is displayed. |
| 4WD WARN LAMP [ON/OFF] | - | - | x | Control status of AWD warning lamp is displayed. |
| 4WD MODE SW [AUTO/LOCK] | - | - | x | SNOW mode switch signal status via CAN communication line is displayed. |
| 4WD MODE MON [AUTO/LOCK] | - | - | x | Control status of AWD is displayed. (Output condition of SNOW indicator lamp signal) |
| DIS-TIRE MONI [mm] | - | - | x | Improper size tire installed condition is displayed. |
| P BRAKE SW [ON/OFF] | - | - | x | Parking switch signal status via CAN communication line is displayed. |
| Voltage [V] | - | - | x | The value measured by the voltage probe is displayed. |
| Frequency [Hz] | - | - | x | The value measured by the pulse probe is displayed. |
| DUTY-HI (high) [%] | - | - | x | |
| DUTY-LOW (low) [%] | - | - | x | |
| PLS WIDTH-HI [msec] | - | - | x | |
| PLS WIDTH-LOW [msec] | - | - | x | |