Testing Condition:
Before performing the following procedure, confirm that battery voltage is between 11.0V and 16V at idle.
WITH CONSULT-II
- Turn ignition switch ON and select DATA MONITOR mode with CONSULT-II. See Figure .
- Start engine and warm it up to the normal operating temperature.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and keep the engine speed between 3,500 and 4,000 rpm for at least 1 minute under no load.
- Let engine idle for 1 minute.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .