DTC Confirmation Procedure
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
WITH CONSULT-II
- Start engine and warm it up to normal operating temperature.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Select DATA MONITOR mode with CONSULT-II. See Figure .
- Restart engine and let it idle for 25 seconds.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
WITH GST
- Start engine and warm it up to normal operating temperature.
- Turn ignition switch OFF and wait at least 10 seconds.
- Restart engine and let it idle for 25 seconds.
- Turn ignition switch OFF and wait at least 10 seconds.
- Restart engine and let it idle for 25 seconds.
- Select MODE 3 with GST.
- If DTC is detected, go to DIAGNOSTIC PROCEDURE
.
- When using GST, DTC Confirmation Procedure should be performed twice as much as when using CONSULT-II because GST cannot display MODE 7 (1st trip DTC) concerning this diagnosis. Therefore, using CONSULT-II is recommended.