Procedure For Malfunction A And B: Notes

WITH CONSULT-II 

1. Turn ignition switch ON and wait at least 1 second.
2. Select DATA MONITOR mode with CONSULT-II. See Figure .
3. Shift selector lever to D position and wait at least 3 seconds.
4. Turn ignition switch OFF, wait at least 10 seconds.
5. Turn ignition switch ON and wait at least 1 second.
6. Shift selector lever to D position and wait at least 3 seconds.
7. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
8. If DTC is detected, go to DIAGNOSTIC PROCEDURE  .