11. Check EVAP Canister Purge Volume Control Solenoid Valve Operation

With CONSULT-II 

1. Disconnect vacuum hose to EVAP canister purge volume control solenoid valve at EVAP service port.
2. Start engine.
3. Perform "PURG VOL CONT/V" in "ACTIVE TEST" mode.
4. Touch "Qu" on CONSULT-II screen to increase "PURG VOL CONT/V" opening to 100%.
5. Check vacuum hose for vacuum when revving engine up to 2,000 RPM.
   1. Vacuum should exist. 

OK or NG 

OK : GO TO 14. CHECK EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE .

NG : GO TO 13.