With Consult-II
- Start engine and warm it up to normal operating temperature
- Turn ignition switch OFF and wait at least 10 seconds
- Turn ignition switch ON and select "SELF-LEARNING CONT" in "WORK SUPPORT" mode with CONSULT-II
- Clear the self-learning coefficient by touching "CLEAR"
- Turn ignition switch OFF and wait at least 10 seconds
- Start engine and keep the engine speed between 3,500 and 4,000 RPM for 1 minute under no load
- Let engine idle for 1 minute
- Keep engine speed between 2,500 and 3,000 RPM for 20 minutes
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
Courtesy of NISSAN MOTOR CO., U.S.A.