Diagnostic Procedure
- Check the following if "CONTROLLER FAILURE [C1201]" is displayed in self-diagnostic results of CONSULT-II.
- PERFORM SELF-DIAGNOSIS
With CONSULT-II
- Turn ignition switch "ON". (Do not start engine.)
- Select "SELF-DIAG RESULTS" mode for "ALL MODE AWD/4WD" with CONSULT-II.
- Touch "ERASE".
- Turn ignition switch "OFF" and wait at least 10 seconds.
- Perform the self-diagnosis again.
Is the "CONTROLLER FAILURE [C1201]" displayed?
YES : Replace AWD control unit. Refer to "AWD CONTROL UNIT ".
NO : INSPECTION END