ASCD Clutch Switch (M/T Models)

WARNING: This page is about a different variant/trim than selected.

Check continuity between ASCD clutch switch terminals 1 and 2 under the following conditions.

CONTINUITY REFERENCE

CONDITION	Continuity
Clutch pedal: Fully released	Should exist
Clutch pedal: Slightly depressed	Should not exist

Fig 1: Identifying Continuity Between Harness Connector terminals 1 And 2

Courtesy of NISSAN MOTOR CO., U.S.A.

If NG, adjust ASCD clutch switch installation, refer to "CLUTCH PEDAL ", and perform step 3 again.