BCM Status Control

BCM changes its status depending on the operation status in order to save power consumption.

1. CAN communication status
   • With ignition switch ON, CAN communicates with other control units normally.
   • Control by BCM is being operated properly.
   • When ignition switch is OFF, switching to sleep mode is possible.
   • Even when ignition switch is OFF, if CAN communication with IPDM E/R and combination meter is active, CAN communication status is active.
2. Sleep transient status
   • This status shuts down CAN communication when ignition switch is turned OFF.
   • It transmits sleep request signal to IPDM E/R and combination meter.
   • Two seconds after CAN communication of all control units stops, sleep transient status switches to CAN communication inactive status.
3. CAN communication inactive status
   • With ignition switch OFF, CAN communication is not active.
   • With ignition switch OFF, control performed only by BCM is active.
   • Three seconds after CAN communication of all control units stops, CAN communication inactive status switches to sleep status.
4. Sleep status
   • BCM is activated with low power mode.
   • CAN communication is not active.
   • When CAN communication operation is detected, it switches to CAN communication status.
   • When a state of the following switches changes, it switches to CAN communication status.
   • Key switch (ACC, ON)
   • Key slot
   • Intelligent Key (lock/unlock signal)
   • Hazard switch
   • Door lock/unlock switch
   • Front door switch (driver side, passenger side)
   • Rear door switch (LH, RH)
   • Trunk lid opener switch
   • Combination switch (passing, lighting switch 1ST position, front fog lamp)
   • Key cylinder switch
   • When control performed only by BCM is required by switch, it shifts to CAN communication inactive mode.
   • Status of combination switch reading function is changed to low power consumption mode.