LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2006 >> M35 Base >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 51 (Engine Control System - Introduction) >> On Board Diagnostic (OBD) System >> Emission-related Diagnostic Information >> System Readiness Test (SRT) Code >> How to Display SRT Status >> No Tools
April 5, 2026: LEMON Manuals is launched! Read the announcement.

No Tools

WARNING: This page is about a different car, the 2006 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

A SRT code itself can not be displayed while only SRT status can be.

  1. Turn ignition switch ON and wait 20 seconds.
  2. SRT status is indicated as shown below.
    • When all SRT codes are set, MIL lights up continuously.
    • When any SRT codes are not set, MIL will flash periodically for 10 seconds.
      Fig 1: Display SRT Status In DTC Confirmation Mode
      G04132545Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals