Inspection Procedure

Turn ignition switch OFF.
Connect "GST" to data link connector (1), which is located under LH dash panel near the hood opener handle.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Enter the program according to instruction on the screen or in the operation manual.
(*: Regarding GST screens in this information, sample screens are shown.)

Fig 2: Displaying Program Card
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform each diagnostic mode according to each service procedure.
For further information, see the GST Operation Manual of the tool maker.

Fig 3: Displaying OBD II Functions

Courtesy of NISSAN MOTOR CO., U.S.A.