Circuit Tester Reference Value
CAUTION:
When checked using a circuit tester for voltage measurement, connector terminals should not be forcefully extended.
CIRCUIT TESTER REFERENCE VALUE
| Terminal | Measuring point | Measuring condition | Standard | ||
|---|---|---|---|---|---|
| + (wire color) | - | ||||
| 1 (L) | - | CAN-H | - | ||
| 4 (G) | Ground | RR MAIN SIG | Neutral | Approx. 2.4 V | |
| 5 (W) | RR VCC | Ignition switch ON | Approx. 5 V | ||
| Ignition switch OFF | Approx. 0 V | ||||
| 7 (R) | RR SUB SIG | Neutral | Approx. 2.4 V | ||
| 8 (P) | - | CAN-L | - | ||
| 15 (B/W) | Ground | RR SEN GND | - | Continuity exit | |
| 22(P/L) | STOP/L SW | Brake pedal depressed | Battery voltage (Approx. 12 V) | ||
| Brake pedal not depressed | Approx. 0 V | ||||
| 25 (L/W) | RLY | Ignition switch ON | Battery voltage (Approx. 12 V) | ||
| Ignition switch OFF | Approx. 0 V | ||||
| 26 (G/W) | WARN | ON | Approx. 1.4 V or less | ||
| OFF | Ignition voltage: 2.8 V or more | ||||
| 27 (G/B) | IGN | Ignition switch ON | Battery voltage (Approx. 12 V) | ||
| Ignition switch OFF | Approx. 0 V | ||||
| 34 (B) | GND | - | Continuity exit | ||
| 36 (LG) | P/S SOL | Normal (Vehicle speed) | 0 km/h (0 MPH) | Approx. 4.4 - 6.6 V | |
| 100 km/h (62 MPH) | Approx. 2.4 - 3.6 V | ||||
| In fail-safe mode (Engine speed) | 0 - 1,500 rpm | Approx. 4.4 - 6.6 V | |||
| 1,500 - 3,000 rpm | Approx. 3.5 V | ||||
| 3,000 rpm or more | Approx. 2.1 V | ||||
| 37 (L/Y) | MOTOR VCC | Ignition switch ON | Battery voltage (Approx. 12 V) | ||
| Ignition switch OFF | Approx. 0 V | ||||
| 38 (W) | MTR-1 (RH) | - | |||
| 39 (B) | MTR-2 (LH) | - | |||
| 40 (B/W) | MOTOR GND | - | Continuity exit | ||