Setting Change Function
The settings of the automatic driving position system can be changed, using CONSULT-II and the display unit in the center of the instrument panel.
AUTOMATIC DRIVING POSITION SYSTEM SETTINGS
| Setting item | Content | CONSULT-II (WORK SUPPORT) | Display unit | Factory setting |
|---|---|---|---|---|
| EXITING OPERATION PART SET | The applied parts at exit can be selected from the following 4 modes. | Mode 1 Steering wheel and seat | - | x |
| Mode 2 Steering wheel only | - | |||
| Mode 3 Seat only | - | |||
| Mode 4 No operation | - | |||
| Tilt Steering Wheel When Exiting Vehicle | Tilt of the steering wheel at entry and exit can be selected: ON (operated)-OFF (not operated) | - | ON: Indicator lamp ON | x |
| OFF: Indicator lamp OFF | - | |||
| Sliding Driver Seat When Entry / Exiting Vehicle | The seat sliding turnout and return at entry/exit can be selected: ON (operated)-OFF (not operated) | - | ON: Indicator lamp ON | x |
| OFF: Indicator lamp OFF | - | |||
| x: Applicable -: Not applicable | ||||
NOTE:
After the setting is registered, the new setting is effective, even if the battery is disconnected.