Inspection Procedure

With CONSULT-II 

1. Turn ignition switch "ON". (Do not start engine.)
2. Select "SELF-DIAG RESULTS" mode for "VDC" with CONSULT-II.
3. Touch "ERASE".
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Check the self-diagnostic results.
   SELF-DIAGNOSIS RESULTS
   
   

   Self-diagnosis results
   ENGINE SIGNAL 2
   ENGINE SIGNAL 3
   ENGINE SIGNAL 4
   ENGINE SIGNAL 5
   ENGINE SIGNAL 6

Is above displayed in the self-diagnosis display? 

1. YES : GO TO 2.
2. NO : INSPECTION END

1. Perform ECM self-diagnosis. Repair or replace items indicated, then perform ECM self-diagnosis again. Refer to "TROUBLE DIAGNOSIS ".
2. Perform VDC/TCS/ABS control unit self-diagnosis again.

OK or NG 

1. OK : INSPECTION END
2. NG:
   • Repair or replace malfunctioning components.
   • Perform the self-diagnosis, and make sure that the result shows "NO DTC IS DETECTED".