Check Sliding Sensor Circuit

1. CHECK FUNCTION 

   With CONSULT-II 

   Check operation with "SLIDE PULSE" on the DATA MONITOR to make sure the pulse changes.

   Fig 1: Identifying CONSULT II Display - DATA MONITOR

   Courtesy of NISSAN MOTOR CO., U.S.A.
   SLIDE PULSE FUNCTION (WITH CONSULT-II)
   
   

   Monitor item [OPERATION or UNIT]	Contents
   SLIDE PULSE	The seat sliding position (pulse) judged from the sliding sensor signal is displayed.

   Fig 2: Identifying Signal Between Driver Seat Control Unit Connector And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   Without CONSULT-II 

   1. Turn ignition switch OFF.
   2. Check signal between driver seat control unit connector and ground, with oscilloscope.
   SLIDE PULSE FUNCTION (WITHOUT CONSULT-II)
   
   

   Connector	Terminals (Wire color)		Condition	Signal (Reference value)
   	(+)	(-)
   B152	18 (G/L)	Ground	Sliding motor operation	Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   OK: Sliding sensor circuit is OK.

   NG: GO TO 2.

2. CHECK SLIDING SENSOR HARNESS CONTINUITY 

1. Disconnect driver seat control unit connector and sliding motor connector.
2. Check continuity between driver seat control unit connector B152 terminals 18, 28C and sliding motor connector B161 terminals 18, 28.

   18 (G/L) - 18 (G/L) : Continuity should exist. 

   28C (B/W) - 28 (B/W) : Continuity should exist. 

3. Check continuity between driver seat control unit connector B152 terminals 18, 28C and ground.

   18 (G/L) - Ground : Continuity should not exist. 

   28C (B/W) - Ground : Continuity should not exist. 

   Fig 3: Checking Sliding Sensor Harness Continuity

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace sliding motor.

NG: Repair or replace harness between driver seat control unit and sliding motor.