Check Tilt Sensor Circuit

1. CHECK TILT SENSOR 

   With CONSULT-II 

   With "TILT SEN" on the DATA MONITOR, operate the tilt switch to make sure voltage changes.

   Fig 1: Identifying CONSULT II Display - DATA MONITOR

   Courtesy of NISSAN MOTOR CO., U.S.A.
   TILT SEN (WITH CONSULT-II)
   
   

   Monitor item [OPERATION or UNIT]		Contents
   TILT SEN	"V"	The tilt position (voltage) judged from the tilt sensor signal is displayed.

   Without CONSULT-II 

   1. Turn ignition switch OFF.
   2. Check voltage between automatic drive positioner control unit connector and ground.
   Fig 2: Identifying Voltage Between Automatic Drive Positioner Control Unit Connector And Ground
   Courtesy of NISSAN MOTOR CO., U.S.A.
   AUTOMATIC DRIVE POSITIONER CONTROL UNIT CONNECTOR AND GROUND (WITHOUT CONSULT-II)
   
   

   Connector	Terminals (Wire color)		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   M49	7 (Y/R)	Ground	Tilt top position	2
   			Tilt bottom position	4

   OK or NG 

   OK: Tilt sensor circuit is OK.

   NG: GO TO 2.

2. CHECK HARNESS 

1. Disconnect automatic drive positioner control unit connector and tilt sensor and telescopic sensor connector.
2. Check continuity harness between automatic drive positioner control unit connector M49 terminals 7 and tilt sensor and telescopic sensor connector M28 terminals 2.

   7 (Y/R) - 2 (Y/R) : Continuity should exist. 

3. Check continuity harness between automatic drive positioner control unit connector M49 terminals 7 and ground.

   7 (Y/R) - Ground : Continuity should not exist. 

   Fig 3: Identifying Continuity Harness Between Automatic Drive Positioner Control Unit Connector M49 Terminals 7 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace tilt sensor and telescopic sensor.

NG: Repair or replace harness between automatic drive positioner control unit and tilt sensor and telescopic sensor.