LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2007 >> FX35 AWD >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Shift Control System >> Control Device Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Device Removal and Installation: Removal

CAUTION: Make sure that parking brake is applied before removal/installation.
  1. Disconnect lower lever of control device and control rod.
  2. Remove knob cover (1) below selector lever downward.
  3. Pull lock pin (2) out of selector lever knob (3).
    Fig 1: Identifying Knob Cover, Lock Pin Of Selector Lever Knob
    G05218126Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove selector lever knob (3).
  5. Remove A/T console finisher. Refer to "COMPONENT PARTS DRAWING ".
  6. Remove center console. Refer to "COMPONENT PARTS DRAWING ".
  7. Remove rear ventilator duct 2. Refer to "REMOVAL AND INSTALLATION ".
  8. Remove key interlock cable (1) from control device. Refer to "REMOVAL AND INSTALLATION ".
    9. Fig 2: Identifying Key Interlock Cable And A/T Device Harness Connector
    G05218127Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Disconnect A/T device harness connector (2).
  10. Remove control device assembly.
scientia non olet · About LEMON Manuals