Check Limit Switch Circuit (Passenger Side)

CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) LIMIT SIGNAL

Turn ignition switch ON.
Check voltage between front power window motor (passenger side) connector and ground.

Fig 1: Identifying Voltage Between Front Power Window Motor (Passenger Side) Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

FRONT POWER WINDOW SWITCH (PASSENGER SIDE) LIMIT SIGNAL

Connector	Terminals (Wire color)		Condition	Voltage [V] (Approx.)
Connector	(+)	(-)	Condition	Voltage [V] (Approx.)
D38	5 (GY)	Ground	Passenger side door window is between fully-open and just before fully-closed position (ON)	0
D38	5 (GY)	Ground	Passenger side door window is between just before fullyclosed position and fullyclosed position (OFF)	5

OK or NG

OK: Limit switch circuit is OK.

NG: GO TO 2.

CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect front power window motor (passenger side) connector.
3. Check continuity between front power window motor (passenger side) connector D38 terminal 6 and ground.
  6 (SB) - Ground : Continuity should exist.
OK or NG

OK: GO TO 4.

NG: GO TO 3.
CHECK HARNESS CONTINUITY 1
1. Disconnect front power window switch (passenger side) connector.
2. Check continuity between front power window switch (passenger side) connector D36 terminal 3 and front power window motor (passenger side) connector D38 terminal 6.
  3 (SB) - 6 (SB) : Continuity should exist.
  
  Fig 3: Identifying Continuity Between Front Power Window Switch And Front Power Window Motor (Passenger Side) Connector D38 Terminal 6
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

OK: Replace front power window switch (passenger side).

NG: Repair or replace harness.
CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) OUTPUT SIGNAL
1. Turn ignition switch ON.
2. Check voltage between front power window switch (passenger side) connector D36 terminal 15 and ground.
  15 (GY) - Ground : Approx. 5V
  
  Fig 4: Identifying Voltage Between Front Power Window Switch (Passenger Side) Connector D36 Terminal 15 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

OK: GO TO 5

NG: Replace front power window switch (passenger side).
CHECK HARNESS CONTINUITY 2
1. Turn ignition switch OFF.
2. Disconnect front power window switch (passenger side) connector.
3. Check continuity between front power window switch (passenger side) connector D36 terminal 15 and front power window motor (passenger side) connector D38 terminal 5.
  15 (GY) - 5 (GY) : Continuity should exist.
  
  OK or NG
  
  OK: Replace front power window motor (passenger side).
  
  NG: Repair or replace harness.
  
  Fig 5: Identifying Continuity Between Front Power Window Switch Connector D36 Terminal 15 & Front Power Window Motor Connector D38 Terminal 5
  Courtesy of NISSAN MOTOR CO., U.S.A.