Inspection Procedure

Check the self-diagnostic results.

Is the above displayed in the self-diagnosis display item? 

Yes: GO TO  2.

No: INSPECTION END

1. Disconnect stop lamp switch connector and ABS actuator and electric unit (control unit) connector E56 and check terminals for deformation, disconnection, looseness, and so on. If any malfunction is found, repair or replace terminal.
2. Securely reconnect connectors.
3. Perform self-diagnosis again.

OK or NG 

OK: Connector terminal contact is loose, damaged, open or shorted.

NG: GO TO  3.

1. Turn ignition switch OFF and disconnect stop lamp switch harness connector.
2. Operate stop lamp switch and check continuity between stop lamp switch harness connector terminals.
Fig 1: Identifying Continuity Between Stop Lamp Switch Harness Connector Terminals
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO  4.

NG: Replace stop lamp switch. Refer to "COMPONENTS ".

1. Turn ignition switch OFF and disconnect stop lamp switch connector E210 and ABS actuator and electric unit (control unit) connector E56.
2. Check continuity between stop lamp switch harness connector and ABS actuator and electric unit (control unit) harness connector.
Fig 2: Identifying Continuity Between Stop Lamp Switch Harness Connector And ABS Actuator And Electric Unit Harness Connector
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Connect connectors and perform an ABS actuator and electric unit (control unit) self-diagnosis.

NG: Open or short in harness between stop lamp switch and ABS actuator and electric unit (control unit). Repair or replace applied harness.