Vehicle Security Operation Check
- INSPECTION START
Turn ignition switch "OFF" and pull out Intelligent Key from key slot.
NOTE: Before starting operation check, open front windows.GO TO 2.
- CHECK SECURITY INDICATOR LAMP
- Lock doors using Intelligent Key or mechanical key.
- Check that security indicator lamp illuminates for 30 seconds.
Security indicator lamp should illuminate.
OK: GO TO 3.
NG: Perform diagnosis and repair. Refer to , "COMPONENT FUNCTION CHECK ".
- CHECK ALARM FUNCTION
- After 30 seconds, security indicator lamp will start to blink.
- Open any door or hood before unlocking with Intelligent Key or mechanical key, or open trunk lid without Intelligent Key or mechanical key.
Do alarm function properly.
OK: GO TO 4.
NG: Check the following.
- The vehicle security system does not phase in alarm mode. Refer to , "SYMPTOM TABLE ".
- Alarm (horn, headlamp and hazard lamp) do not operate. Refer to , "SYMPTOM TABLE ".
- CHECK ALARM CANCEL OPERATION
Unlock any door or open trunk lid using Intelligent Key or mechanical key.
Alarm (horn, headlamp and hazard lamp) should stop.
OK: INSPECTION END.
NG: Check door lock function. Refer to "INTELLIGENT KEY : SYSTEM DESCRIPTION ".