ID Registration With Transmitter Activation Tool

1. With the ignition switch in OFF position, connect CONSULT-II and CONSULT-II CONVERTER to the Data Link Connector (DLC). Turn ignition switch to ON position.
2. Select "START (NISSAN BASED VHCL)".
3. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
   NOTE: This screen display may not appear just after starting engine or turning ignition switch to ON position. In this case, reconnect CONSULT-II and CONSULT-II CONVERTER.
4. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
5. With the Transmitter Activation Tool (J-45295) pushed against the front left transmitter tire air valve, press the button for 5 seconds. See Fig 1.
6. Register the IDs in the specified order:
   • 2003-07:  When ID registration of each wheel has been completed, a buzzer sounds as indicated and the turn signal light flashes. See ID Registration Order Specifications (2003-07)  table.
   • 2008-10:  Front Left, Front Right, Rear Right, Rear Left - When ID registration of each wheel has been completed, the turn signal light flashes 2 times.
   ID Registration Order Specifications (2003-07)
   
   

   Tire Position	Buzzer Will Sound
   Front Left	Once
   Front Right	2 Times
   Rear Right	3 Times
   Rear Left	4 Times

   NOTE: Be sure to register the IDs in the specified order, or the self-diagnostic results display will not function properly.
7. After completing all ID registrations, press "END" to complete the procedure.

Fig 1: Identifying Transmitter Activation Tool (J-45295)

Courtesy of NISSAN MOTOR CO., U.S.A.