- With the ignition switch in OFF position, connect CONSULT-II and CONSULT-II CONVERTER to the Data Link Connector (DLC). Turn ignition switch to ON position.
- Select "START (NISSAN BASED VHCL)".
- Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
NOTE:
This screen display may not appear just after starting engine or turning ignition switch to ON position. In this case, reconnect CONSULT-II and CONSULT-II CONVERTER.
- Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
- Adjust the tire pressure to the specified values for ID registration, and drive the vehicle at 25 mph (40 km/h) or more for a few minutes. See ID Registration Tire Pressure Specifications (2003-04) or ID Registration Tire Pressure Specifications (2006)
table.
ID Registration Tire Pressure Specifications (2003-04)
| Tire Position |
Tire Pressure - psi (kPa) |
| Front Left |
36 (250) |
| Front Right |
33 (230) |
| Rear Right |
30 (210) |
| Rear Left |
27 (190) |
ID Registration Tire Pressure Specifications (2006-10)
| Tire Position |
Tire Pressure - psi (kPa) |
| Front Left |
34 (240) |
| Front Right |
31 (220) |
| Rear Right |
29 (200) |
| Rear Left |
26 (180) |
- After completing all ID registrations, press "END" to complete the procedure.
- Inflate all tires to specification.