LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2007 >> M35 x >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Body, Lock & Security System >> Intelligent Key System/Engine Start Function >> Operation Description >> Push-Button Ignition Switch Operation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Push-Button Ignition Switch Operation Procedure

The power supply position changing operation can be performed with the following operation.

NOTE:
  • When an Intelligent Key is within the detection area of inside key antenna and when it is inserted to the key slot, it is equivalent to the operations below.
  • When starting the engine, the Intelligent Key unit monitors the engine start conditions (brake pedal operating condition, A/T selector lever position, and vehicle speed).
  • Unless each start condition is fulfilled, the engine will not respond regardless of how many times the engine switch is pushed. At that time, illumination repeats the position in the order of LOCK→ACC→ON→LOCK.
PUSH-BUTTON IGNITION SWITCH OPERATION PROCEDURE

Power supply position Engine start/stop condition Push-button ignition switch operation frequency
Brake pedal A/T selector lever position
LOCK → ACC Not depressed
(When A/T selector lever is in any position other than P or N, there will be no effect even if it is depressed.)		 Any position other than P or N (When the brake pedal is not depressed, there will be no effect even if the A/T selector lever is in P or N position.) 1
LOCK → ACC → ON Not depressed
(When A/T selector lever is in any position other than P or N, there will be no effect even if it is depressed.)		 Any position other than P or N (When the brake pedal is not depressed, there will be no effect even if the A/T selector lever is in P or N position.) 2
LOCK → ACC → ON → LOCK Not depressed
(When A/T selector lever is in any position other than P or N, there will be no effect even if it is depressed.)		 Any position other than P or N (When the brake pedal is not depressed, there will be no effect even if the A/T selector lever is in P or N position.) 3
LOCK → START
ACC → START
ON → START
(Engine start)		 Depressed P or N position ((1)) 1
[If the switch is pushed once, the engine starts from any power supply position (LOCK, ACC, and ON)]
Engine is running → LOCK (Engine stop) - P position 1
Engine is running → ACC
(Engine stop)		 - Any position other than P ((2)) 1
Engine stall return operation while driving - N position 1
(1) When the A/T selector lever position is N position, the engine start condition is different according to the vehicle speed.
  • At vehicle speed of 5 km/h or less, the engine can start only when the brake pedal is depressed.
  • At vehicle speed of 5 km/h or more, the engine can start even if the brake pedal is not depressed. (It is the same as "Engine stall return operation while driving".)
(2) When the A/T selector lever position is in any position other than P position and when the vehicle speed is 5 km/h or more, the engine stop condition is different.
  • Press and hold the push-button ignition switch for 2 seconds or more. (When the push-button ignition switch is pressed for too short a time, the operation may be invalid, so properly press and hold to prevent the incorrect operation.)
  • Press the push-button ignition switch 3 times or more within 1.5 seconds. (Emergency stop operation)
scientia non olet · About LEMON Manuals