LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2013 >> EX37 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Brake System) >> On-Vehicle Repair >> Front Disc Brake >> Brake Caliper Assembly >> Disassembly and Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install bleeder valve and cap.
  2. Apply rubber grease to piston seals (1), and install them to cylinder body.
    CAUTION: Never reuse piston seals.
    Fig 1: Identifying Piston Seals
    G05208000Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Apply rubber grease to piston boots (1). Cover the piston (2) end with piston boot, and then install cylinder side lip on piston boot securely into a groove on cylinder body.
    CAUTION: Never reuse piston boots.
    Fig 2: Applying Rubber Grease To Piston Boots
    G05208001Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Apply brake fluid to pistons (1). Push piston into cylinder body by hand and push piston boot (2) piston-side lip into the piston groove.
    CAUTION: Press the pistons evenly and vary the pressing point to prevent cylinder inner wall from being rubbed.
    Fig 3: Pushing Piston Boot Piston-Side Lip Into Piston Groove
    G05207995Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Apply rubber grease to bushing, and install bushing to sliding pin.
  6. Apply rubber grease to sliding pins and sliding boots, and install sliding pins and sliding pin boots to torque member.
  7. Install the cylinder body to the torque member and tighten the sliding pin bolts to the specified torque.
scientia non olet · About LEMON Manuals