LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2013 >> FX37 Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1089 To P2138 >> DTC P2122, P2123: App Sensor >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK GROUND CONNECTION 
    1. Turn ignition switch OFF.
    2. Check ground connection M95. Refer to "CIRCUIT INSPECTION ".

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair or replace ground connection.

  2. CHECK APP SENSOR 1 POWER SUPPLY CIRCUIT 
    1. Disconnect accelerator pedal position (APP) sensor harness connector.
    2. Turn ignition switch ON.
    3. Check the voltage between APP sensor harness connector and ground.
      APP sensor Ground Voltage (V)
      Connector Terminal
      E112(1) 5 Ground Approx. 5
      E116(2) 5
      (1) Without ICC
      (2) With ICC

      Is the inspection result normal? 

      YES: GO TO  4.

      NO: GO TO 3.

  3. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors M6, E106
    • Harness for open or short between ECM and accelerator pedal position sensor

      : Repair open circuit, short to ground or short to power in harness or connectors.

  4. CHECK APP SENSOR 1 GROUND CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between APP sensor harness connector and ECM harness connector.
      APP sensor ECM Continuity
      Connector Terminal Connector Terminal
      E112(1) 4 M164 100 Existed
      E116(2) 1
      (1) Without ICC
      (2) With ICC
    4. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 5.

  5. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors M6, E106
    • Harness for open or short between ECM and accelerator pedal position sensor

      : Repair open circuit, short to ground or short to power in harness or connectors.

  6. CHECK APP SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Check the continuity between APP sensor harness connector and ECM harness connector.
      APP sensor ECM Continuity
      Connector Terminal Connector Terminal
      E112(1) 3 M164 97 Existed
      E116(2) 4
      (1) Without ICC
      (2) With ICC
    2. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO  8.

      NO: GO TO 7.

  7. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors M6, E106
    • Harness for open or short between ECM and accelerator pedal position sensor

      : Repair open circuit, short to ground or short to power in harness or connectors.

  8. CHECK APP SENSOR 

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO  10.

    NO: GO TO 9.

  9. REPLACE ACCELERATOR PEDAL ASSEMBLY 
    1. Replace accelerator pedal assembly.
    2. Go to "SPECIAL REPAIR REQUIREMENT ".

      : INSPECTION END

  10. CHECK INTERMITTENT INCIDENT 

    Refer to "INTERMITTENT INCIDENT ".

    : INSPECTION END

scientia non olet · About LEMON Manuals