Work Procedure When Replacing Control Unit

Perform zero point reset. Refer to "ZERO POINT RESET: SPECIAL REPAIR REQUIREMENT ".

Is zero point reset performed normally? 

YES: INSPECTION END

NO: Check condition as per the following, and perform zero point reset again.

• Passenger seat is occupied by an object.
• Excessive vibration is applied while performing zero point reset.
• Occupant detection system is malfunctioning.
  NOTE: If "Incomplete" is displayed on "zero point reset current status", zero point reset is not completed normally. Check the condition as per the following and perform zero point reset again.
• Passenger seat is occupied by an object.
• Excessive vibration is applied while performing zero point reset.
• Occupant detection system is malfunctioning.