DTC Confirmation Procedure
NOTE:
Every time when "C1929" is detected, either the ABS actuator ad electric unit (control unit) or the RAS control unit simultaneously detects a DTC that leads to a direct cause of the malfunction.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
: GO TO 2.
- DTC REPRODUCTION PROCEDURE
With CONSULT
- Turn the ignition switch from OFF to ON.
- Perform "4WAS (MAIN)/RAS/HICAS" self-diagnosis.
Without CONSULT
- Start the engine.
- Perform the self-diagnosis. Refer to
"DIAGNOSIS DESCRIPTION ".
Is DTC "C1929" or "RAS warning lamp flickering pattern: 26" detected?
YES: Proceed to diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END