CONFIGURATION (AV CONTROL UNIT): Special Repair Requirement
- SAVING VEHICLE SPECIFICATION
-CONSULT Configuration
Perform "Before Replace ECU", and save the current vehicle specification in CONSULT.
Is the vehicle specification saved normally?
YES: GO TO 2.
NO: GO TO 4.
- REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to "REMOVAL AND INSTALLATION ".
: GO TO 3.
- WRITING VEHICLE SPECIFICATION
-CONSULT Configuration
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to AV control unit.
: GO TO 6.
- REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to "REMOVAL AND INSTALLATION ".
: GO TO 5.
- WRITE VEHICLE SPECIFICATION
CONSULT Configuration
Select "Manual Configuration", and write the setting value as shown in the following table to AV control unit according to the vehicle specification.
CAUTION: Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.NOTE:- The items shown in this list depend on vehicle specifications.
- The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
MANUAL SETTING ITEM Detail Items Setting value STEERING LHD LHD models RHD RHD models CAMERA SYSTEM NONE/AVM Without camera system or with around view monitor system REAR CAMERA With rear view monitor system REAR+SIDE With rear view monitor system and front-side view monitor function SOUND SYSTEM BASE Without BOSE system BOSE With BOSE system AUXILIARY INPUT JACKS WITH With auxiliary input jacks WITHOUT Without auxiliary input jacks NOTE: AVM: Around view monitor: GO TO 6.
- PERFORM SELF-DIAGNOSIS
CONSULT Self Diagnostic Result
Perform self-diagnosis of CONSULT, and check whether or not DTC U122A is detected.
Is DTC U122A detected?
: GO TO 5.
: GO TO 7.
- OPERATION CHECK
Check that the operation of the AV control unit and camera images (fixed guide lines and predictive course lines) are normal.
: WORK END