DTC Confirmation Procedure

PRECONDITIONING
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  TESTING CONDITION:
  
  Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.
  
  : GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE-I
1. Turn ignition switch ON (engine stopped) and wait at least 10 seconds.
  CAUTION: Never start engine during this procedure.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Check 1st trip DTC.
  Is 1st trip DTC detected?
  
  YES: Proceed to "DIAGNOSIS PROCEDURE ".
  
  NO: GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE-II
1. Start engine.
2. Rev up the engine quickly to approximately 3, 000 RPM under unloaded condition and completely release the accelerator pedal.
3. Let the engine idle and wait at least 10 seconds.
4. Turn ignition switch OFF and wait at least 10 seconds.
5. Turn ignition switch ON.
6. Check 1st trip DTC.
  Is 1st trip DTC detected?
  
  YES: Proceed to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END