DTC Confirmation Procedure
- PRECONDITIONING
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.
: GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and wait at least 10 seconds.
- Turn ignition switch OFF and wait at least 10 seconds.
- Repeat step 1 and 2 for 5 times.
- Turn ignition switch ON.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END