DTC Detection Logic

NOTE: If DTC P1089 or P1092 is displayed with DTC P1608, first perform the trouble diagnosis for DTC P1608. Refer to "DTC LOGIC ".

DTC No.	Trouble diagnosis name	DTC detecting condition	Possible cause
P1089	VVEL control shaft position sensor (bank 1) circuit	An excessively low voltage from the sensor is sent to VVEL control module. An excessively high voltage from the sensor is sent to VVEL control module. Rationally incorrect voltage is sent to VVEL control module compared with the signals from VVEL control shaft position sensor 1 and VVEL control shaft position sensor 2.	Harness or connectors (VVEL control shaft position sensor circuit is open or shorted.) VVEL control shaft position sensor VVEL control module
P1092	VVEL control shaft position sensor (bank 2) circuit