Detail Flow
SEAT - DETAIL FLOW
| Order | Input | Output | Control unit condition |
|---|---|---|---|
| 1 | Power seat switch (sliding, lifting, reclining) | - | The power seat switch signal is inputted to the driver seat control unit when the power seat switch is operated. |
| 2 | - | Motors (sliding LH, lifting LH, reclining LH) | The driver seat control unit outputs signals to each motor according to the power seat switch input signal. |
TILT AND TELESCOPIC - DETAIL FLOW
| Order | Input | Output | Control unit condition |
|---|---|---|---|
| 1 | ADP steering switch | - | The ADP steering switch signal is input to the automatic drive positioner control unit when the ADP steering switch is operated. |
| 2 | - | Motors (tilt, telescopic) | The automatic drive positioner control unit actuates the motors according to the operation of the ADP steering switch signal. |
| 3 | Sensors (tilt, telescopic) | - | The automatic drive positioner control unit recognizes any operation limit of each actuator via each sensor and will not operate the motors anymore at that time. |
DOOR MIRROR - DETAIL FLOW
| Order | Input | Output | Control unit condition |
|---|---|---|---|
| 1 | Door mirror remote control switch | - | The door mirror remote control switch signal is inputted to the automatic drive positioner control unit when the door mirror remote control switch is operated. |
| 2 | - | Motors (Door mirror motor) | The automatic drive positioner control unit actuates each motor according to the operation of the door mirror remote control switch. |
NOTE:
The door mirrors can be operated manually when ignition switch is in either ACC or ON position. The ignition switch signal (ACC/ON) is transmitted from BCM to the driver seat control unit via CAN communication and from the driver seat control unit to the automatic drive positioner control unit via UART communication.