April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Function Check

INSPECTION START
1. Turn ignition switch OFF.
2. Perform "INSPECTION MODE 5". Refer to "WORK PROCEDURE (INSPECTION MODE 5) ".
3. Start engine.
  Does the engine start?
  
  YES-1: With CONSULT: GO TO 2.
  
  YES-2: Without CONSULT: GO TO 3.
  
  No: Go to "DIAGNOSIS PROCEDURE ".
CHECK IGNITION SIGNAL FUNCTION
With CONSULT
1. Perform "POWER BALANCE" in "ACTIVE TEST" mode of "ENGINE" with CONSULT.
2. Make sure that each circuit produces a momentary engine speed drop.
  Is the inspection result normal?
  
  YES: INSPECTION END
  
  NO: Go to "DIAGNOSIS PROCEDURE ".

CHECK IGNITION SIGNAL FUNCTION

Without CONSULT

Let engine idle.
Read the voltage signal between ECM harness connector terminals under the following conditions with an oscilloscope.

ECM				Voltage signal
+		-
Connector	Terminal	Connector	Terminal
F101	11	M107	128
	12
	15
	16
	19
	20

NOTE: The pulse cycle changes depending on RPM at idle.

Is the inspection result normal?

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE ".