HPCM: Work Procedure

WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM HPCM RECOMMUNICATING FUNCTION
1. Install HPCM.
2. Contact backside of registered Intelligent key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.
  *: To perform this step, use the key that is used before performing HPCM replacement.
3. Maintain ignition switch in the ON position for at least 5 seconds.
4. Turn ignition switch OFF.
5. Check that the vehicle can be set to READY.
: GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING HPCM
Perform the following procedure, HBC-98, "Work Procedure".

: END