Ready Set Condition Table By Push-Button Ignition Switch Operation
WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.
The vehicle can be set to READY by the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
- When setting the vehicle to READY, the BCM monitors the following conditions.
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
VEHICLE SPEED - LESS THAN 4 KM/H (2.5 MPH)
| Vehicle condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| OFF → ACC | - | Not depressed | 1 |
| OFF → ACC → ON | - | Not depressed | 2 |
| OFF → ACC → ON → OFF | - | Not depressed | 3 |
| OFF → READY ACC → READY ON → READY |
P or N position | Depressed | 1 |
| READY → OFF | - | - | 1 |
VEHICLE SPEED - 4 KM/H (2.5 MPH) OR MORE
| Vehicle condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| READY → ACC | - | - | Emergency stop operation |
| ACC → READY (Return operation after emergency stop operation while driving) |
N position | - | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.