Component Function Check

With CONSULT

1. Start the engine.
2. Shift the selector lever to "P" position.
3. Select "Data Monitor" in "AT/CVT".
4. Select "ATF TEMP 1".
5. Warm up until the below condition is satisfied.

   ATF TEMP 1: 45 - 55°C (113 - 131°F)

6. Select "Data Monitor" in "MOTOR CONTROL".
7. Select "SUB E-OP PRESSURE" and "SUB E-OP TORQUE".
8. Set the vehicle to idling stop state.
9. Check value.

   SUB E-OP PRESSURE: Approx. 550 kPa

   SUB E-OP TORQUE: 0.52 - 0.62 Nm

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE ".