Physical Values
| Terminal No. (Wire color) | Description | Condition | Value (Approx.) | ||
|---|---|---|---|---|---|
| + | - | Signal name | Input/Output | ||
| 1 (R) | - | 4WAS front motor V terminal | - | - | - |
| 2 (LG) | Ground | Front wheel angle sensor signal (sin) | Input | Ignition switch: ON | 0 - 5 V |
| 3 (B) | - | 4WAS front lock solenoid valve ground | - | - | - |
| 4 (B) | - | Front wheel angle sensor ground | - | - | - |
| 5 (L) | - | 4WAS front motor U terminal | - | - | - |
| 6 (G) | - | 4WAS front motor W terminal | - | - | - |
| 7 (V) | Ground | Front wheel angle sensor signal (cos) | Input | Ignition switch: ON | 0 - 5 V |
| 8 (P) | Ground | Front wheel angle sensor signal (Excitation) | Output | Ignition switch: ON | 0 - 5 V |
| 10 (Y) | Ground | 4WAS front lock solenoid valve power supply | Output | Ignition switch: ON | Battery voltage |
| Ignition switch: OFF (Wait 10 min. or more.) | 0 V | ||||
| 11 (R) | Ground | 4WAS front motor power supply | Input | Ignition switch: ON | Battery voltage |
| Ignition switch: OFF (Wait 10 min. or more.) | 0 V | ||||
| 12 (B) | Ground | 4WAS front motor ground | - | Always | 0 V |
| 14 (R) | - | 4WAS communication-L | - | - | - |
| 15 (W) | Ground | Ignition switch power supply | Input | Ignition switch: ON | Battery voltage |
| Ignition switch: OFF | 0 V | ||||
| 18 (B) | Ground | Ground | - | Always | 0 V |
| 25 (L) | - | 4WAS communication-H | - | - | - |
| 34 (B) | Ground | Ground | - | Always | 0 V |
CAUTION:
When using circuit tester to measure voltage for inspection, never forcibly extend any connector terminals.