Component Inspection (Fuel Rail Pressure Sensor)

WITH CONSULT

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Select "DATA MONITOR" mode with CONSULT.
5. Check that the "FUEL PRES SEN V" indication.

   Monitor Item	Condition	Values/Status
   FUEL PRES SEN V	Engine speed: Idle	820 - 1, 220 mV
   	Engine speed: Revving engine from idle to 4, 000 rpm quickly	820 - 3, 060 mV

WITHOUT CONSULT

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Check FRP sensor signal voltage.

   +		-		Condition	Value (Approx.)
   ECM
   Connector	Terminal	Connector	Terminal
   F110	31	F110	40	[Engine is running] Warm-up condition Idle speed	0.82 - 1.22 V
   				[Engine is running] Warm-up condition Revving engine from idle to 4, 000 rpm quickly	0.82 - 3.06 V

   Is the inspection result normal? 

   YES: INSPECTION END.

   NO: Replace FRP sensor. Refer to "EXPLODED VIEW ".