LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2013 >> M56 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0190 To P1084 >> DTC P0191: FRP Sensor >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

NOTE: Turning the ignition switch ON with FRP sensor harness connector disconnected causes ECM to detect DTC P0190. Be sure to erase the DTC when the diagnosis procedure.
  1. CHECK FRP SENSOR POWER SUPPLY-I 
    1. Turn ignition switch OFF.
    2. Disconnect FRP sensor connector.
    3. Turn ignition switch ON.
    4. Check the voltage between FRP sensor harness connector terminals.
      FRP sensor Voltage (Approx.)
      Connector + -
      terminal
      F6 1 3 5 V

      Inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 2.

  2. CHECK FRP SENSOR POWER SUPPLY-II 

    Check the voltage between FRP sensor harness connector and the ground.

    + - Voltage (Approx.)
    FRP sensor
    Connector Terminal
    F6 1 Ground 5 V

    Is inspection result normal? 

    YES: GO TO  4.

    NO: GO TO 3.

  3. CHECK SENSOR POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check harness connector for short to power and short to ground, between the following terminals.
      ECM Sensor
      Connector Terminal Name Connector Terminal
      F110 27 Power steering pressure sensor F35 3
      Low fuel pressure sensor F39 3
      28 FRP sensor F6 1
      Engine oil pressure sensor F32 3

      Is inspection result normal? 

      YES: Perform the trouble diagnosis for power supply circuit. Refer to "DIAGNOSIS PROCEDURE ".

      NO: Repair or replace error-detected parts.

  4. CHECK FRP SENSOR GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between FRP sensor harness connector and ECM harness connector.
      + - Continuity
      FRP sensor ECM
      Connector Terminal Connector Terminal
      F6 3 F110 40 Existed

      Is inspection result normal? 

      YES: GO TO 5.

      NO: Repair or replace error-detected parts.

  5. CHECK ECM GROUND CIRCUIT 

    Check the continuity between ECM harness connector and the ground.

    ECM Ground Continuity
    Connector Terminal
    F110 10 Ground Existed
    M160 114
    115
    174
    175

    Is inspection result normal? 

    YES: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

    NO: Repair or replace error-detected parts.

  6. CHECK FRP SENSOR SIGNAL CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between FRP sensor harness connector and ECM harness connector.
      + - Continuity
      FRP sensor ECM
      Connector Terminal Connector Terminal
      F6 2 F110 31 Existed
    4. Also check harness for short to ground and to power.

      Is inspection result normal? 

      YES: GO TO 7.

      NO: Repair or replace error-detected parts.

  7. CHECK FRP SENSOR 

    Refer to "COMPONENT INSPECTION (FUEL RAIL PRESSURE SENSOR) ".

    Is inspection result normal? 

    YES: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

    NO: Repair or replace error-detected parts.

scientia non olet · About LEMON Manuals