Component Inspection (Throttle Position Sensor)

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform "WORK PROCEDURE ".
4. Turn ignition switch ON.
5. Set selector lever position to D.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition	Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F111	91 [TP sensor 1 (bank 1)]	97	Accelerator pedal: Fully released	More than 0.36
   			Accelerator pedal: Fully depressed	Less than 4.75
   	71 [TP sensor 1 (bank 2)]	69	Accelerator pedal: Fully released	More than 0.36
   			Accelerator pedal: Fully depressed	Less than 4.75
   	79 [TP sensor 2 (bank 1)]	97	Accelerator pedal: Fully released	Less than 4.75
   			Accelerator pedal: Fully depressed	More than 0.36
   	89 [TP sensor 2 (bank 2)]	69	Accelerator pedal: Fully released	Less than 4.75
   			Accelerator pedal: Fully depressed	More than 0.36

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

Replace malfunctioning electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".

: INSPECTION END