DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

   : GO TO 2.

WITH CONSULT

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Select "DATA MONITOR" mode with CONSULT.
4. Check that "COOLAN TEMP/S".
   • If it is between 5°C (41°F) and 40°C (104°F) go to the following steps.
   • If it is below 5°C (41°F) warm engine up to more than 5°C (41°F) and retry from step  1.
   • If it is above 40°C (104°F) cool engine down to less than 40°C (104°F) and retry from step  1.
5. Start engine and let it idle for 5 minutes.
6. Check 1st trip DTC.

WITH GST

Follow the procedure "With CONSULT" above.

Is 1st trip DTC detected? 

YES: Proceed to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END