DTC Confirmation Procedure
- PRECONDITIONING
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 8 V or more at idle.
Which DTC is detected?
P2100: GO TO 2.
P2103: GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE FOR DTC P2100
- Turn ignition switch ON and wait at least 2 seconds.
- Start engine and let it idle for 5 seconds.
- Check DTC.
Is DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END
- PERFORM DTC CONFIRMATION PROCEDURE FOR DTC P2103
- Turn ignition switch ON and wait at least 1 second.
- Check DTC.
Is DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END