Component Inspection (Accelerator Pedal Position Sensor)

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Turn ignition switch ON.
4. Check the voltage ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   M160	136 (APP sensor 1)	140	Accelerator pedal	Fully released	0.45 - 1.0
   				Fully depressed	4.4 - 4.8
   	126 (APP sensor 2)	129		Fully released	0.22 - 0.5
   				Fully depressed	2.1 - 2.5

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

Replace accelerator pedal assembly.

Refer to "MODELS WITHOUT DISTANCE CONTROL ASSIST SYSTEM: REMOVAL AND INSTALLATION " (Without distance control assist system).

Refer to "MODELS WITH DISTANCE CONTROL ASSIST SYSTEM: REMOVAL AND INSTALLATION " (With distance control assist system).

: INSPECTION END