DTC Confirmation Procedure

PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  TESTING CONDITION:
  - Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.
  - Before performing the following procedure, check that the fuel tank is 1/8 full of fuel.
    : GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE-I
WITH CONSULT
1. Start engine.
2. Select "COOLAN TEMP/S" in "DATA MONITOR" mode of "ENGNE" using CONSULT.
3. Maintain the following condition for 5 seconds or more at idle.
  
  COOLAN TEMP/S : 70°C (104°F) or more
4. Check 1st trip DTC.
  WITH GST
  
  Follow the above steps for "WITH CONSULT".
  
  Is 1st trip DTC detected?
  
  YES: Proceed to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END